This tool calculates the **maximum distance** (miles or km) that can be achieved in a communication system using the transmitter power and receiver sensitivity in **dBm**.

The system includes a transmitter, transmit antenna, receiver and receive antenna.

To calculate the max distance, enter the following:

- Transmit Power (dBm)
- Receiver Sensitivity (dBm)
- Frequency of operation (Hz/KHz/MHz/GHz)
- Transmit Antenna Gain (dBi)
- Receive Antenna Gain (dBi)
- Total Cable and Other Losses (dB)

**Formula**

The calculator uses the Free Space Path Loss (FSPL) equation:

**FSPL = 20*Log _{10}(d) + 20*Log_{10}(f) + L_{c} + 20*Log_{10}(4π/c) – G_{Tx} – G_{Rx}**

to calculate **d**

**20*Log _{10}(d)** =

**FSPL – 20*Log**

_{10}(f) – L_{c}– 20*Log_{10}(4π/c) + G_{Tx}+ G_{Rx}**d = 10^((1/20)*(FSPL – 20*Log _{10}(f) – L_{c} – 20*Log_{10}(4π/c) + G_{Tx} + G_{Rx}))**

**Example Range Calculation**

At a frequency of 2450 MHz (ISM band) and transmit power of +20 dBm, let’s take a look at the range of a Wi-Fi system in free space.

With a receive sensitivity of -90 dBm, transmit and receive antenna gain of 0 dBi, and 0 dB cable loss, the maximum distance is **3.1 km** or **1.9 miles.**

Important to remember that this calculation is outdoors and free space which is an ideal condition.

Assuming indoor conditions, using our indoor Wi-Fi range calculator the same level of received signal is achieved at only **55 meters**. A much smaller range. This is to be expected as signals are attenuated more indoors than in free space.

**How to use the Calculator**

**Frequency of operation**

This is the frequency at which the communication system operates. The range is higher at lower frequencies, so entering the highest operating frequency will give you an upper limit on the achievable range. In the case of L-band for instance, use f = 2.1 GHz.

**Transmit Power**

This is the power at the output connector of the transmitter. It is usually specified in dBm. If specified in Watt, use this calculator to convert to dBm.

**Transmit Antenna Gain**

This depends on the type of antenna used and is expressed in dBi. It can be calculated from the Antenna Factor and frequency of operation.

**Receiver Sensitivity**

Minimum level of input signal that a radio receiver can detect and demodulate. Use this calculator to find the sensitivity.

**Receive Antenna Gain**

Depends on antenna used and is expressed in dBi. In cases where the signal is from a particular direction, a high gain antenna (8 dBi for instance) can be used. This allows focusing of energy instead of from all directions. It can be calculated from the Antenna Factor and frequency of operation

**Total Cable and Other Losses**

This includes losses between connectors and antennas. If splitters are used, the loss should be accounted for as well. It is specified in dB. Use this calculator to find the loss due to antenna cable.